- 8 years ago
- Wedding: September 2010
This is my DIY for my beaded belt. It’s pretty straight forward but this also includes my supplies.
Satin Ribbon. You can find this almost anywhere – just don’t get wire-edged.
Seed Beads: I used two sizes in silver instead of clear because I wanted some sparkle.
Crystals: I used Gem-Cut Rondells (this link is for a larger size I used 8mm) and Bicones that were 4mm and 6mm. All of these were crystal colored – NOT crystal AB – which has the multicolored oil sheen
Rhinestones: I ordered sew-on rhinestones in two sizes (12ss & 20ss) from ebay
You will also need Fabric/Bead Glue and a Beading Needle along with beading thread. Oh, and plenty of patience and time!
READY TO GO?!
Measure the length you want the belt to be and add 2 inches so you can finish the ends. I used satin ribbon that was 1.5″ wide.
Apply the glue to the ribbon in 1-2″ sections with a paint brush. Make sure you put a decent amount on just not so much that it soaks thru.
Sprinkle your seed beads onto the wet glue and pat them gently with your hand to make sure they stick. Wait for this to dry completely before doing anything else
Lay your lenght of ribbon along a ruler and spread your beads out evenly along the side of it (you don’t HAVE to do this it just helps you make sure you don’t end up with a bunch in one spot).
Bead, bead and bead. I tied a seed bead to the end of the thread before pulling it thru so it wouldn’t pull out. I worked one section with all the beads instead of doing one type at a time. It’s good to have this some place where you can work on it for 30 mins at a time and then walk away from it. Makes it WAY less overwhelming.
When you get done you’ll realize that you’ve lost some seed beads in the process. I went back and filled in any holes at the very end.
Lightly singe the ends of the ribbon to keep it from fraying and then fold them under and hand sew them flat. At this point you can either add hooks or you can do some sort of pretty clasp. Another idea is to cut the ribbon much longer than you need, bead only the part for your waist and then tie it into a bow at the back.